A Review Of alliant rl-26
A Review Of alliant rl-26
Blog Article
The graph on the initial site of that topic need to encourage you that Alliant 410 isn't the powder to make use of with AA-HS hulls.
Have shot in -20 already. When a great rigid breeze comes out in the north, a person human being constantly claims "It's a dry chilly".
Only difficulty with not reaming the shot bushing to toss 226 of shot inside of a HS hull with .296" powder bushing, would be the shot will probably rattle inside the shell (my Model of the apply only load When the shot rattles any time you shake the round).
Also, ensure that you set the crimper as much as crimp to your depth of a couple of dime, and be sure to are only a bit taper crimping the hulls.
I concur, Really don't operate off reaming anything at all until eventually you have loaded enough to generally be self-confident in the stack peak.
The data furnished on this Site is for normal uses only and doesn't represent professional suggestions. We make every energy to ensure the accuracy and reliability of the data, but we do not warranty its completeness or suitability for any unique intent.
We are engineers, reloading fans and function one of the most powerful ballistics calculators.
I am able to confirm from 1st hand knowledge which the 13gr. load functions just like a allure with a load of three @ 0.395" balls; my loads had been plastic shells but I see no rationale why it wouldn't function with entire duration metallic shells.
The person accessing this site assumes the chance of safe loading methods. Failure to do so could end in serious private damage (or Demise) and/or property damage.
The information shown on This page, such as ballistic data, was derived from tightly controlled laboratory disorders.
The information supplied on this Web site is for standard reasons only and isn't going to constitute professional guidance. We make each and every work to ensure the accuracy and trustworthiness of the data, but we don't warranty its completeness or suitability for almost any unique reason.
Your rammer tube might be established the original source way too minimal. I haven't loaded .410, but I suspect that the thirty lb. you have to move the indicator is an excessive amount of for the .410 wad. Test ramming a wad With all the clamp free and find out In the event the rammer tube moves up. If it does, consider a crimp. If that is too high, reduced and champ the tube about fifty percent way.
The best ballistic technicians and high top quality components are brought with each other to be sure every single gun is better served with Accurate Powders.
Notice: You should not have confidence in the charts!!!! Do a number of throws With all the new bushing with your device and bodyweight great post to read the throws to confirm that you are obtaining the correct grain drops.